FXMQ200MFV1

Original source notes

Extracted from the catalogue page and its facing page, where available. Notes may refer to other models or optional accessories.

Notes: *1. Specifications are based on the following conditions:
• Cooling: Outdoor temp. of 33°CDB, 28°CWB (68% RH), and discharge temp. of 18°CDB.
• Heating: Outdoor temp. 0°CDB, -2.9°CWB (50% RH), and discharge temp. of 25°CDB.
• Equivalent reference piping length: 7.5 m (0 m horizontal)
*2. An intake filter is not supplied, so be sure to install the optional long-life filter or high-efficiency filter.
*3. Anechoic chamber conversion value, measured at a point 1.5 m downward from the unit centre.
These values are normally somewhat higher during actual operation as a result of ambient conditions.
*4. It is possible to connect to the outdoor unit if the total capacity of the indoor units is 50% to 100% of the capacity index of the outdoor unit.
*5. Local setting mode is not displayed on the remote controller.
• This equipment cannot be incorporated into the remote group control of the VRV system.
Options
232
sretliF
MODEL FXMQ125MFV1 FXMQ200MFV1 FXMQ250MFV1
Operation remote controller BRC1H63W(K) / BRC1E63 / BRC2E61
DTP401A61
DTP401A62
DCS302CA61
DCS301BA61
DST301BA61
KRP4AA51
lortnoc/noitarepO
This unit is intended for the treatment of outdoor air only. Not to be used for maintaining indoor air temperature. Be sure that the discharge airflow will not
blow on people directly.
Group control of the product and standard indoor units is not supported. A separate remote controller should be connected to individual unit.
If the unit is utilised to operate 24 hours a day, maintenance (part replacement, etc.) must be performed periodically.
Temperature setting and Power Proportional Distribution (PPD) are not possible even if the intelligent Touch Controller or the intelligent Touch Manager is installed.
The remote controller wired to the outdoor-air processing unit must not be set as the master remote controller. Otherwise, when set to “Auto,” the operation mode
will switch according to the outdoor air conditions, regardless of the indoor temperature.
Central remote controller
Unified ON/OFF controller
Schedule timer
Wiring adaptor for electrical appendices (2)
Long-life replacement filter KAF371N140 KAF371N280
Colourimetric method 65% KAF372M140 KAF372M280
High-efficiency filter
Colourimetric method 90% KAF373M140 KAF373M280
Filter chamber * KDJ3705L140 KDJ3705L280
Streamer duct chamber BDEZ500A140VE BDEZ500A510VE
Drain pump kit KDU30L250VE
Adaptor for wiring KRP1B61
Notes: * Filter chamber has a suction-type flange. (Main unit does not.)
• Dimensions and weight of the equipment may vary depending on the options used.
• Some options may not be usable due to the equipment installation conditions, so please confirm prior to ordering.
• Some options may not be used in combination.
• Operating sound may increase somewhat depending on the options used.
tnempiuqE
tnemtaerT
riA
Air Treatment Equipment
Simple touch controller
AC adaptor for simple touch controller

Notes:
2
1
.
.
T
T
p h
h
ip e
e
i n s
o
y g
p
s
e
t le e
r
n
a
m g
t i
t w
o
h
n
i : l l 7
r a
n .5
n
o
g
t m
e
o , p
s
H
h
e e
o
r i a
w
g t h e
n
t i
i
n d
n
i f f
t
a f
h
e n
e
r e m
g
n
r
o
a
c d e
p
: e
h
0 w
i s
m h
u
. e
n
n
d
t
e
h
r
e
t h
o
e
u t
f
d
o
o
ll
o
o
r
w
a
in
ir
g
t e
co
m
n
p
d
e
i
r
t
a
io
t
n
u
s
r
.
e
E
i
q
s
u
5
i
°
v
C
a l
o
e
r
n t
below.
–5 15 19 (33.5) 43
231